Beastx MICROBEAST PLUS, Manual, Page: 137 / 353

57 Adjustment on the device
1. Move the stick(s) for aileron and elevator on the radio and check whether the
swashplate is moved correctly on the helicopter.
(Note for beginners: the swashplate must follow the stick movement, so pushing elevator
forward will tilt the swashplate forwards, adding aileron to the right will move the swash
to the right and so on.)
If the stick is moving the swashplate into the wrong direction use the reverse
function of your transmitter
and reverse the aileron and/or elevator channel in the
transmitter to set stick control direction correctly.
2. Now set the internal control direction for the MICROBEAST PLUS gyro: When you
push elevator
forwards , the Status LED must light up or flash in blue color. When you
pull elevator backwards , the Status LED must light up or flash in red color. When you
move aileron to the right , the Status LED must light up or flash in blue color. When
you move aileron to the left , the Status LED must light up or flash in red color. When
the display is inverted (red = right or forwards and blue = left or backwards)
reverse the display (internal control direction) by tapping the rudder stick.
There are four possible options, only one is correct! In short: aileron right + elevator
forwards the Status LED must be blue , aileron left + elevator backwards the
Status LED must be red. When the LED is purple or shines in the contrary color,
you've not set the correct option.
3. Optional: When you move stick(s) to full deflection , the Status LED should light
solid , not just flash. If this is not the case, increase the servo throw/endpoint of the
aileron and elevator channel in the transmitter just as far so that the Status
LED changes from flashing to solid when the stick(s) reach the end positions
. (Note: Do not increase the endpoints too much in the transmitter. We need an exact
match of full stick position and stick end position. So the Status LED should just change
from flashing to solid when reaching the end positions.)
Always set servo direction in the transmitter first, then check the display on the
MICROBEAST PLUS and change the internal control direction if it does not match
the real direction.
Do not change the internal direction in order to change the
servo direction! This is only used for telling the gyro in which direction it
must move the swashplate.
Be very conscientious when doing this setup step, as
wrong gyro direction will cause loss of control during takeoff and you probably crash
the helicopter!
129