®
RS34 - RS48 - RS59
8
BEAST BRIDGE SAWS OPERATING MANUAL
WARNING: It is important to not
abuse the extension cord and do
not yank on any cord to discon-
nect it from the outlet.
WARNING: It is important to
keep the cord away from heat
and sharp edges.
WARNING: It is important to dis-
connect the extension cord from
the outlet before disconnecting
the machine from the extension
cord.
WARNING: It is important not to
use an extension cord that is
undersized. Using an undersized
extension cord can result in low
voltage to the motor thus result-
ing in a motor burnout or prema-
ture failure.
To choose the proper extension cord:
•
Locate the length of extension cord
needed in the table below
•
Once the proper length is found, move
down the column to obtain the correct
•
AWG size required for that length of
extension cord.
Extension Cord Minimum Gage for Length
Volts
Total Length of Cord [ft]
120V
25
50
100
150
AWG AWG AWG AWG
14
12
Not recommended
Tile Specific Warnings:
WARNING:
•
Always wear eye and hearing
protection.
•
Always disconnect the saw
before conducting any type of
service on the machine, includ-
ing when changing cutting
blades and cleaning.
•
Use the machine only with
Beast 10” wet cutting blades.
•
Always replace damaged cut-
ting blade before operating.
MACHINE SPECIFICATIONS
This sawing machine is designed and
intended for the professional contractor.
The machine is equipped with a saw
head which moves horizontally along a
guiding beam. The material to be cut is
positioned on the saw table. The saw
must be fed through the material. Through
continuous supply of cooling water the
cutting quality is improved as well as the
wear on the saw blade is minimized. The
cooling water also absorbs the saw dust.
The quality and construction of this sawing
machine meet the highest standards. The
design is based on longevity and minimal
maintenance.
The stainless steel construction contributes
to a stable, rigid and durable sawing
machine. The 4 detachable legs are to be
installed in the leg sockets at the underside
of the water container and fastened with
the knobs.
Cutting head
The cutting head is constructed of cast
alloy components. The height adjustment
is kept in balance with a spring. A knob
secures the cutting head at the desired
height.
Blade guard
The blade guard is a stainless steel plate
cap with a removable blade cover which
is fastened by 3 knobs.
Saw spindle
The spindle flange is mounted on the saw
