®
RS34 - RS48 - RS59
10
BEAST BRIDGE SAWS OPERATING MANUAL
Setting the Cutting Depth
CAUTION: By loosening the
knob the saw head can
be positioned at the desired
height.
The saw head is tightened by a spring
and may accidentally jump up when the
knob is loosened.
Cooling system
CAUTION: Operating the water
pump without a sufficient supply
of water may result in pump
damage.
•
Place the plug in the drain of the water
container.
•
Fill the container with water until the
water pump is completely submerged.
Connecting to power supply
CAUTION: Before connecting the
machine make sure that:
•
the line voltage corresponds
with the data on the machine’s
specifications plate;
•
there is a grounded power
supply;
•
the extension cord’s meets crit-
erea as mentioned in the table
on page 8.
Motor protection
The motor is equiped with a thermal safety
switch for protection against an overload.
When the motor gets overheated, the
switch falls back into its initial position and
can only be switched on again after the
motor has cooled down.
Replacing the cutting blade
WARNING: Make sure to dis-
connect the machine from the
power supply before fitting or
replacing the cutting blade or
when doing any maintenance on
the machine.
•
Remove the three knobs of the blade
cover.
•
Block the sawing spindle with the 6
mm Allen wrench.
•
Unscrew the 22 mm hexagon nut
with the wrench and remove the saw
flange. (Attention: Left-handed screw
threading.)
•
Clean the saw flanges.
•
Fit the new cutting blade on the center
ring of the motor flange. (Check the
direction of rotation and make sure the
blade is well centered.)
•
Mount saw flange and tighten with the
hexagon nut.
