www.beast-tek.com
Dirty Glitch Assembly Manual
| 23
Check the alignment of everything and make sure everything is sitting flush.
Using a tube spanner or ring spanner (to avoid scratching the front panel) place and tighten a nut onto
the rotary encoder.
Place washers and nuts onto the 4 pots. Tighten the nuts, again using a tube spanner or ring spanner to
avoid scratching the front panel.
The three smaller remaining nuts are for the SPST switches. Inspect them carefully as often one side of
the nut usually has a slightly raised edge from the zinc plating process, whilst the other side is smooth.
Install the nuts onto the SPST switches with the SMOOTH side of the nut facing the panel. If the nuts are
screwed on with the raised side of the nut facing the panel, it may scratch the panel. Tighten the nuts on
the SPST switches using a tube or ring spanner.
Inspect the panel and board to make sure the panel is flat and everything is sitting flush / neatly.
Use a straight edge or square make sure the panel is straight. Because the controls and jacks have not
been soldered, it is still possible to make gentle adjustments to make everything flush/square.
