www.beast-tek.com
Dirty Glitch Assembly Manual
| 16
Interface Board
IMPORTANT!!
Note: all components facing the front of the module are to be mounted on the reverse
side / back / side WITHOUT the silk screen. Please refer to the photos within the build guide.
Step 1
Peel the protective film from the 7 segment displays D1, D2 and D3. Insert them onto the BACK of the
PCB (side without silk screen). Double check that they are oriented correctly using the decimal points on
the display as a guide.
Once the orientation has been confirmed, solder one lead from each display and check that they sit
flush with the board. If they are not flush, they can be adjusted easily by heating the single solder joint
and maneuvering them into place. Once you are happy, solder the rest of the leads and trim.
Step 2
On the component side, insert the BAT 85 diodes D4, D5, D6, D7, D8, D9, D10, D11 being careful of the
orientation. Make sure the black stripe on the diode aligns with the stripe printed on the PCB. Also
insert the 10uf electrolytic capacitor C1. Double check the orientation, solder in place and trim leads.
