resistor
IN OUT
IN OUT
IN OUT
120
Ω
Rear
29. AUDIO input socket
30. MIDI input socket
31. DMX POLARITY selector
32. DMX output socket
33. DMX input socket
34. DC input socket
35. POWER ON / OFF switch
Setup
Sound Control
Sound control works through the built-in microphone or through the LINE IN socket. Connect the sound signal from a
mixer (e.g. MASTER 2) with the AUDIO input socket (29) on the rear panel.
DMX512 Connection
Only use a stereo shielded cable and 3-pin XLR plugs in order to connect the controller with the 1st scanner (effect)
and one scanner (effect) with another.
Adjust the XLR polarity via the DMX POLARITY selector (31).
A DMX signal terminator is recommended to avoid a bad signal caused by other electrical devices. A DMX terminator is a
XLR connector with a 120
Ω
resistor between pin 2 and pin 3 of the XLR connector. Connect it to the last OUTPUT socket
of the final scanner.
Scanner address
The DMX starting address should be assigned every 20 channels.
Address every projector to the respective starting address
otherwise the channel assignment will not be correct. Light effects
with the same starting address will work synchronous.
Scanner
Nr.
DMX
Start
Address
Scanner
Nr.
DMX
Start
Address
1 1 7 121
2 21 8 141
3 41 9 161
4 61 10 181
5 81 11 201
6 101 12 221
