Beamz 154.060, Instruction Manual

Page: 9 / 18

www.beamzlighting.com
5) Select now via the BANK arrow keys the memory bank into which you wish to store the copied scene.
6) Press now the MIDI/REC (MIDI/ADD) key and afterwards the SCENE key containing the number of the scene into
which you wish to store the copied settings.
7)
To confirm the copy, the LED’s and the display flash a few times.
8) Switch the program mode off by pressing the PROGRAM key.
CLEARING A SCENE
1) This function allows to reset all 16 DMX channels in a scene.
2) Switch the programming mode on and select via the BANK arrow keys the memory bank that contains the scene to
be removed.
3) Keep the AUTO/DEL key pressed while pushing the relevant scene key.
4)
The LED’s flash to confirm and the scene is erased.
CLEARING (RESET) ALL SCENES (CAUTION !)
1) This allows you to erase all programmed scenes at once.
2) Press the PROGRAM key and then the BANK down arrow key. Keep both keys pressed.
3) Switch now the unit off by unplugging the connector of the power supply. Release both keys.
4) Power the unit on again.
DUPLICATION OF A MEMORY BANK
1) This function allows you to transfer at once all 8 programmed scenes from a memory bank into another memory
bank.
2) Switch the programming mode on by pressing the PROGRAM key until the PROG LED is flashing on the display.
3) Select the memory bank you wish to copy via the arrow keys.
4) Press the MIDI/REC (MIDI/ADD) key once.
5) Select now via the arrow keys the number of the memory bank into which you want to copy.
6) Press the MUSIC/BANK-COPY (9) key once. The display flashes to confirm.
7) Switch the programming mode off by pressing the PROGRAM key for 2 seconds. The BLACKOUT mode that is
switched on automatically, can be switched off by the BLACKOUT key.
ERASING A MEMORY BANK
1) This function allows to clear all 8 programmed scenes in a memory bank.
2) Switch the programming mode on by pressing the PROGRAM key until the PROG LED is flashing on the display.
3) Keep the AUTO/DEL pressed while pressing the MUSIC/BANK-COPY key.
4) Release both keys at the same time.
5) The display flashes to confirm.
6) Leave the programming mode by pressing the PROGRAM key for 2 seconds. The BLACKOUT mode that is switched
on automatically, can be switched off by the BLACKOUT key.
PROGRAMMING OF RUNNING LIGHT FUNCTIONS
Attention ! You first need to program scenes into the memory banks before you can use the running light functions.
1) This function allows you to play 240 different scenes in a sequence.
2) Switch the programming mode on by pressing the PROGRAM key until the PROG LED is flashing on the display.
3) Select one of the six running light patterns via the CHASE keys (5).
4) Select the requested scene in one of the memory banks (BANK up/down + SCENE keys).
5) Press the MIDI/REC (MIDI/ADD) key to confirm the selection.
6) You can set up to 240 steps in each of these six running light programs.
7) Repeat the steps 3 to 5 until you have reached the desired effect.
8) Switch the programming mode off by pressing the PROGRAM key for 2 seconds.
CHANGING A RUNNING LIGHT PATTERN
ADDITION OF STEPS