Press
off existing modes. Press
return the last modes.
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press
on the remote controller.
2. Press
or
to choose between the different auto programs.
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press
on the remote controller.
2. Press
or
to choose between the different sound programs.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
3. Press
again to turn off the strobe.
To adjust the speed of the automatic program and the sound active program.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the speed of the program.
To adjust sound sensitivity for in Sound-Active mode
1. Press
on the remote controller.
2. Press
or
to either increase or decrease sound sensitivity.
1. Select adjust master fixture.
2. Press
or
to adjust select master value
1. Press
on the remote controller.
2. Press
or
to adjust preset ID.
3. Press
,
,
,
,
or
(red, green, blue, white, amber or ultraviolet) to choose your colour.
3. Press again
,
,
,
,
or
(red, green, blue, white, amber or ultraviolet) to close your colour.
4. Press
or
to either increase or decrease the percentage of each colour.
Fade mode will enable colour gradiënt.
1. Press
on the remote controller.
2. Press
or
to either increase or decrease the fade time.
To adjust the brightness value of the automatic program, the Sound active program and Manual Mode.
Press digit
to
to change different brightness on the device.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
The fixture has a s built-in timer function. The fixture can show the pre-programmed preset, colour or chase at certain times and dates.
Adjust the battery turn of level on between 5-10%
-
Press
-
Select
, press enter.
-
Select
, press enter.
-
Select
, press enter.
-
Select percentage between 5 and 10% with the up and down buttons.
-
Press
to confirm.
Summary of Contents for BBP54
Page 1: ...BBP54 UPLIGHT 150 602 V1 2...
Page 38: ......
