Beamz Pro BBP54, User Manual

Page: 5 / 38

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
The unit has a powerconnector output on board. Depending on the local conditions several units can be linked by powerconnector in- and output. Connect
a maximum of four (when using 230V/16A) units in a row. Use an approved three-core cable with a cross-section of at least 1.5 mm². The installation
instructions of the manufacturer and the colour coding of the cable must be observed. Do not turn off the unit by turning the powerconnector but use the
power on/off switch or schuko!
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of 154.077 (BBP W-DMX
transmitter/receiver).
Set BBP W-DMX transmitter and receiver into operation by connecting its power unit to the power input and the mains plug to a mains outlet (100-240V~,
50/60 Hz). The status indicator shortly flashes red.
Set each fixture to the same DMX frequency. Go to and select the desired universal, it will be displayed
by colour indication.
As soon as the transmitter receives a DMX signal from the light controller, the status indicator turns red. Shortly thereafter, the status indicators of the
receivers will start flashing green to indicate that the DMX signal is being received. The fixtures can now be controlled via wireless 2.4 GHz DMX signal.
1 Red 1 ~ 512
2 Green 1 ~ 512
3 Yellow 1 ~ 512
4 Blue 1 ~ 512
5 Magenta 1 ~ 512
6 Cyan 1 ~ 512
7 White 1 ~ 512