IsatDock2 LITE - User Manual
19
YELLOW
BLACK
RED
RED
(+) Vin 10 to 32VDC
BLACK
(-) OV Power Ground
YELLOW ON/SLEEP
To Battery Positive Terminal
(Requires 5A Fuse)
To Negative Terminal or chassis
To ON/OFF switch
(1A Fuse recommended)
4) Connecting the DC Power Cable
The DC power cable supplied has three wires,
RED, BLACK and YELLOW.
The RED and BLACK wires are used for the
power connection while the YELLOW wire can
be connected to a vehicle’s accessories, ignition
or a switch.
By default, the IsatDock2 LITE will stay on for 20
minutes after this input is switched off. If a call
is in progress while this occurs, the IsatDock2
LITE will stay on for 20 minutes after the call
is terminated. Please follow the steps below
to connect the DC power cable to the vehicle
battery power and the IsatDock2 LITE.
1.
Route the wire end of the DC power
cable to the connection point. DO NOT
apply power until the following steps
are completed.
2.
Connect the BLACK wire to the negative
terminal of the battery (10A fuse
recommended) or the vehicle chassis (if
Wiring for a Marine Application
When installed in a marine application using the
DC power cable, the YELLOW wire can be wired
to a suitable panel switch which will allow the
IsatDock2 LITE to be turned off when not in use.
Optional ISD950 AC Plug Pack Installation
For installation with the optional ISD950
110-240 AC plug pack connect the 4-way
Microfit connector from the plug pack to the
4-way power connector on the rear cable loom
of the IsatDock2 LITE. In this configuration the
ignition/accessory status is always ON.
negatively grounded chassis).
3.
Connect the RED wire to the positive
terminal of the battery. It is recommended
to add a 5A fuse (supplied) between them.
4.
Connect the YELLOW wire to the vehicle
accessory power. If the accessory power
is unavailable, this may be connected
to a vehicle ignition voltage. It is
recommended to add a 1A fuse between
them. The accessory wire enables the
IsatDock2 LITE to turn on and off as the
vehicle key is enabled or disabled. If this
function is not required, the YELLOW wire
MUST be connected to the RED wire.
5.
Connect the 4-way Microfit connector on
the DC power cable to the 4-way power
connector on the rear cable loom of the
IsatDock2 LITE.
