75.5159.09 20090115
5/10
2
Remote Control adjustments (only when factory settings do not match)
Unlock the sensor to enter into adjustment
session (if no access code has been
entered)
RED LED
Press Unlock key
flashes slowly
To change the value of a parameter
(ex. Maximum duration of presence
detection)
RED LED
RED LED
Select parameter
to change
flashes quickly
Enter new value
flashes slowly
… to change any other parameters
(ex. Output Configuration)
RED LED
RED LED
Select parameter
to change
flashes quickly
Enter new value
flashes slowly
To check the value of a parameter (ex.
maximum duration of presence detection)
…
RED LED
GREEN
GREEN
GREEN
GREEN
RED LED
Select parameter
to check
flashes quickly
Press Question
Mark
The number of green flashes indicate the value of this parameter
flashes slowly
Lock the adjustment session and go back to
normal function
Press Lock key twice
NOTE: LOCK ACCESS CODE:
When unlocking the sensor, if LED
flashes quickly, enter the lock code
OR if lock code is unknown, perform the
following:
Disconnect power from the sensor.
Re-connect power.
Press unlock within 60 seconds to bypass the lock code.
When programming is complete, and the sensor is re-locked, the lock code will
once again be required unless it is deleted as described below.
To re-lock the sensor without a lock
code (or with a new lock code), perform
the following:
To return to no lock code, simply press lock once, followed by 0000.
3
Remote Control Programming: Launch a setup by performing the following:
Unlock the sensor to enter into adjustment
session
RED LED
Press Unlock key
flashes slowly
To launch an assisted setup
required after mechanical adjustments
of the IR sensor module.
required once after the first installation
Press Setup key followed
by 0
RED/GREEN LED
alternating
The sensor performs a door opening and closing cycle to
check the influence of the door leaves to the safety curtains.
See Troubleshooting if RED LED flashes quickly after setup.
This setup is only effective if the relay output (activation) has been wired to the door controllers opening
impulse input. This is required to create a door opening/closing cycle.
LED display during sensor assisted setup
RED/GREEN LED
LED alternating means setup-process active: the sensor learns its environment.
After finishing the setup process, the sensor shows the following behavior:
RED LED flashing quickly
The sensor ‘sees’ the door movement and can not finish its setup.
ORANGE LED continuously on
The sensor encounters a signal saturation
(ex. due to a highly reflective floor).
No LED turns on
The sensor successfully finished its setup.
