75.5159.09 20090115
4/10
4
IR presence sensing field: select the applicable IR lens – narrow or wide (default)
Install the applicable lens into the slots
at bottom side of sensor.
The default lens is wide.
Above 10’ mounting height, use the narrow prism!
5
IR presence sensing field : Adjust the infrared curtain as shown below.
For automatic sliding doors the curtain should reach within 3” of the face of the sliding door panel.
+4°
-4°
0°
The pin shown
here above
indicates the
angle adjusted.
To approach the
curtain to the
door, turn the
screw clockwise.
To tilt the curtain
out, turn the screw
counterclockwise.
Keep
a
minimum distance of 2”
between the door and the first
curtain.
Use the Spotfinder (accessory)
to locate and adjust the position
of the curtains.
When mounting one sensor on each side of the door above a highly reflective threshold, select different frequencies
to avoid crosstalk between the sensors.
1
Important User Guide Symbols
LED turns on
LED flashing slowly LED flashing quickly Presence detection
LED display during normal function
RED LED
Presence detection
ORANGE LED
See chapter 7: Troubleshooting
2 curtains of 24 overlapping spots
(no holes between spots)
2 curtains of 12 overlapping spots
(no holes between spots)
4 Remote Control Set-up
