BE I2500, Operation Manual

Page: 16 / 44

16
4. Set the motor switch in the “ON’-position.
5. Pull slightly on the start cord until you feel resistance and then yank
hard and swiftly.
starting your inverter generator
NOTICE
A hot motor will not start if there is too much fuel in the cylinder. If
this happens, wait five to ten minutes before trying again. Position the
choke completely to the right and the motor should start.
6. After the engine starts, allow the engine to run continuously to warm up.
7. Press the choke in completely after the engine is started.
CAUTION
• DO NOT let the start cord retract by itself; guide it back by hand.
• Hold the carry handle firmly to prevent the generator from falling over
when you pull the start cord.
NOTICE
If the engine stops and will not restart, check the engine oil level before
troubleshooting in other areas.
Engine Switch
Starting Grip
ON
OFF
I2500_3500 Inverter Generator Manual_2011.indd 16 18/10/2011 2:03:49 PM