15
Lighting Instructions
ALL MODELS
1. STOP! Be sure to read all of the Safety Instructions.
2. Check that the valve on the propane cylinder is open.
3. Turn the Heater Regulator Knob clockwise to the “OFF” position.
4. Wait five (5) minutes for any gas to clear. Smell for gas around the
heater, including near the floor. If you do smell gas, STOP! Follow the
Safety Instructions, and check for leaks. If there is no gas smell pro-
ceed to the next step.
5. Turn the Heater Regulator Knob counter-clockwise to the “HI” position,
and press in the Safety shut-off Valve Plunger for five (5) seconds.
NOTE:
When the heater is first connected to the gas supply, the plunger
should be depressed for approximately thirty (30)
seconds to bleed any air from the hose, and release plunger.
6. Insert a lit match into the Ignition hole in the reflector, and the depress
plunger until the burner lights (see Figure 5).
7. Keep the plunger depressed for about thirty (30) seconds after the
burner lights. Then release the plunger, and if the burner stays lit,
remove and extinguish the match. You will know that the burner is lit
when the mesh screen begins to glow red.
8. If the Burner does not stay lit, repeat the lighting process. If the heater
does not light after several attempts, be sure you are getting fuel to the
to the burner. The faint smell of gas will tell you the fuel is flowing. If
not, there may be a problem with your LP cylinder. Take it back to your
local dealer for replacement.
WARNING
Be sure to read and understand all of the Safety Information in this
manual before lighting this heater.
Heater has high surface temperatures. Be sure to keep children, pets
and clothing away from the heater. Be sure to keep Burner and Heater
Regulator clean and free from any debris. Maintain safe distances from
heater.
WARNING
Never use flame to check for leaks.
CAUTION
Do not insert the lit match into the air inlet holes in the mixing tube.
LIGHTING INSTRUCTIONS
