BE Ag & Industrial BE-AGF Series, Operations & Parts Manual

Page: 15 / 24

MAINTENANCE CHECKLIST BE-AGFxxx
FIRST CHECK
• Check the correct tension of the driving belt.
• Check that all bolts and nuts are tightened.
• After the first 50 hours of work, change oil in the gearbox.
EVERY 8 HOURS OF WORK
• Rotate teardrop-shaped Plate (B) and grease the shaft support (driveline side) through the lubricating
Nipple (A) (Picture 1).
• Grease the shaft support (external side) through the lubricating Zerk (A) (Picture 2)
• Grease the shaft support (driveline) and the belt tensioner idler pin through the lubricating Zerks (A) and (B)
(Picture 3).
• Grease the stabilizing roller through the lubricating Zerk (A)
EVERY 50 HOURS OF WORK
• Check the correct tension of the driving belt
• Check that all bolts and nuts are tightened.
• Check the cutters/hammers for wear.
• Check the overgear until oil level through lug (A) (Picture 5).
EVERY 500 HOURS OF WORK
• Check that all bolts and nuts are tightened.
• Change oil in the overgear unit.
EVERY 1000 HOURS OF WORK
• Replace the driving belt.
GEAR BOX MAINTENANCE
• The oil should be drained out and replaced after the first 50 hours of operation, then the oil should be
changed every 250 hours, or at least once a year.
• Drain oil from the gearbox thoroughly. Check an clean it. Fill with new gear oil up to the dedicated oil level.
• The draining procedure is as follows: remove the draining bolt under the gearbox, so that the oil drains off.
After the oil is drained out, put the plug back and fill with gear oil up to the dedicated oil level.