BE Ag & Industrial BE-AGF Series, Operations & Parts Manual

Page: 13 / 24

TRANSPORT & STORAGE BE-AGFxxx
WORKING SPEED
The working speed depends on quality, diameter and height of the material to be cut; anyway, for the efficient
mower performance it must be between 2 and 5 MPH. The power takeoff speed must be 1000 RPM maximum.
Operate the mower at its full rated PTO speed to maintain blade speed for a clean cut.
ROAD TRANSPORT
Extreme caution should be used when transporting the tractor and implement on public roadways. The tractor
must be equipped with all required safety warning features including SMV emblem and flashing warning lights
which are clearly visible from the rear of the unit. Make sure you are in compliance with all local regulations
regarding transporting equipment on public roads and highways. Do not exceed 20 MPH (32 KPH).
Reduce speed on rough roads and surfaces. Always use hazard flashers on the tractor when transporting unless
prohibited by law.
STORAGE
If your shredder will not be used for a long period of time, respect the following suggestions:
1. Wash the machine throughly and dry it.
2. Lubricate all bearings with enough grease to eliminate any cavities where water condensation may occur
and cause damage. Refer to “Maintenance of the Machine” for location of all grease fittings. Be sure the vent
on top of the gearbox is open.
3. Loosen the set nut and spindle jack to relieve drive belt tension
NOTE: Before next season’s use, be sure to adjust the drive belt tension).
4. Coat all exposed surfaces inside the mower with oil or grease to prevent rusting and pitting during storage.
5. Protect the whole machine with tarpaulin and pit it in a dry place.
PRE-SEASON CHECK
1. Check the oil level in the gearbox and lubricate all bearings. See “Lubrication”.
2. Adjust the drive belt tension. See “Drive Belt”.
3. Check out all equipment and replace damaged or worn parts.
4. Tighten all bolts & nuts. See “Torque Specifications”.
5. Inspect for missing and/or broken blades/knives. Replace as necessary. See “Knife Replacement”.
6. Be sure that the safety guards are in place and secure.
7. Run the Flail Mower at a low RPM checking to make sure that all driveline parts are moving freely.
DANGER
Do not exceed the rated PTO speed for the implement. Excessive PTO speeds can
cause driveline or blade failures resulting in serious injury or death.