10
BE-SGGxxx USER MANUAL
Inspect Fuel
SystemCheck for
Leaks
Inspect fuel system & check for leaks BEFORE starting grinder.
WARNING: FUEL LEAK HAZARD
A leaking fuel line no matter how small can be the source of a fire or explosion when
starting or operating the engine.
• Inspect the entire fuel system. Look for: Signs of leaks or deteriora-tion, chafed or
spongy fuel hose, loose connections, loose or missing fuel hose clamps, damaged
gasoline tank, or defective gasoline shut-off valve.
• If grinder is in an enclosed area and you smell gas, DO NOT start engine! DO NOT
light a match. DO NOT flip on an electrical switch. Exit area immediately leaving
doors open and call fire department.
Locking
Handle Bar
Handle is capable of folding when not in use.
Personal
Protection
Use approved protective clothing and approved protective equipment when using the
machine.
• Always wear safety glasses with side shields and a full-face shield.
• The use of ear plugs or other hearing protection device is also recom-mended for
persons working within 15-20 feet (5-6.5m) of the running grinder for longer than a
few minutes. Hearing can be damaged from prolonged, close- range exposure to the
type of noise produced by this grinder.
• Wear long pants to protect legs from sparks, hot engine and flying debris.
• Never wear jewelry or loose-fitting clothing when starting or operating the grinder or
any mechanical device. Loose or dangling apparel, jewelry or hair can become entan-
gled in moving parts.
• Neither the machine as a whole nor its internal
components are intend-ed for use in potential explosive atmospheres.
Trim Stump
with Saw
Cut or trim the stump preferably to ground level using a power saw.
Clear Area
Dig away the earth and remove any stones near the tree stump or roots that may
interfere with your work.
Working During
Daylight Hours
Only use the machine in daylight or in well-lit conditions. Never operate the grinder
after dark.
2. STARTING THE GRINDER
After you have completed the pre-start checking list and procedures, you are ready to start the grinder.
The following directions details how to start the engine of your grinder.
To start the grinder:
Note: For additional engine starting instructions see your gasoline engine manual.
• Lock handle in the upright position.
• Place stump grinder into position with cutting wheel near the front-top edge of the stump.
• Use brake lever on handle to lock the wheel brake.
Note: For tighter brake adjustment, turn knob on top of brake lever. (See Maintenance & Repair sections for
instructions).
WARNING
Never attempt to use the grinder without proper protective equipment, particularly eye protection and
a full-face shield.
