Änderungen vorbehalten – Stand 08.05.2019
17
Please observe the following information when using pad
electrodes.
The skin of the patient/client should be free from oils and without wounds before the
treatment. Potentially applied make up or similar must be removed.
It is very important to make sure that a good adhesive effect is found on the entire
surface of the pad electrodes.
The pad electrodes have to be in contact with the skin with their entire surface during
the treatment and can‘t fall off.
Should the pad electrodes not fulfill the requirements mentioned above, they have to
be replaced with new electrodes.
When using the device on different patients, the pad electrodes have to be replaced
after each use.
Further information can be found in the chapter „Initial Operation“
of this manual.
Patient Cables
The patient cables provide an electrical connection between the microcurrent device BCR
Premium MSTU 100 and the patient.
2 patient cables are provided as accessories with the device.
These cables are to be connected to sockets „A“ and „B“ on the device.
The other end of the patient cable is connected to the pad electrodes or hand electrodes,
which provide a conductive connection to the patient. Depending on the pad electrodes, the
red and black pad electrode adapters are to be used.
The patient cables do not need to be serviced, they should only be cleaned with a damp rag
when necessary.