10
Duo-Scan 3
1.5 BATTery LIFe, MeTerIng AnD ChArgIng
The Duo-Scan 3 runs for approximately 5 hours on a fully charged battery, the current charge
level of the battery is displayed in the lower right of the display
Each bar on the meter represents approximately 1 hour of run time.
The battery meter will flash when there is less than 5 minutes of power remaining.
The current battery voltage is displayed in the lower left of the display, this is primarily for factory use.
Charging
The battery must first be removed from the Duo-Scan 3 before charging.
Attach the battery to the charger by securing both latches.
Once the battery is connected the charger may be plugged in and switched on.
An indication of battery condition may be observed on the charger when the Push button is pressed
and the unit will show the state of battery condition during charging – “Low”, “Good” or “Full”.
The battery will require at least eight hours charging from fully discharged, but may be left connected
for longer without damage.
Duo-Scan 3 manual.indd 10
15/06/2009 21:38
