RS485 Star Card Manual V14 4Feb04.doc Page 13/29
VCL TP – Fixed at 9600,N,8,1 (adjust SW1 to suit input protocol)
Connect dome D+ to Starcard/Converter TRA and dome D- to Starcard/Converter TRB.
Set the dome address using the DIL switch to match the number of the camera input of
the TX1500. Ensure that any dome at the end of a daisy chained RS485 run are have the
RS485 terminated and the intermediate domes have the RS485 determinated.
The following functionality is provided.
Manual pan/tilt control with 16 speed steps from 1 to 127, (slowest to fastest)
Zoom with Manual Iris and Focus override.
Operating the Zoom will re-enable auto focus and iris after manual adjustment
32 preset positions.
2 sequential preset tours of preset positions 1 - 16, tour 1 maximum speed and tour 2
speed 32. The dwell time is fixed at 10 seconds per preset position. Preset positions can
be removed from the tours.
All 28 privacy zones can be programmed and disabled if required.
Advanced Function
TX1500 Procedure
Manual 180 degree pan flip (U turn)
1 #
Program a privacy zone
2 #
followed by
PROGRAM 1-28 PRESET
Clear a privacy zone
3 #
followed by
PROGRAM 1-28 PRESET
Dome remote reset (power cycle)
4 #
Add preset position to the tours
programming a preset position adds the preset
into the tour. (1 – 16 only)
Remove a preset from the tours
PROGRAM 50 PRESET
followed by
1-16 PRESET
Start preset tour 1 – high speed
1 PATROL
(max speed with 10 second dwell)
Start preset tour 2 – slow speed
2 PATROL
(speed 32 with 10 second dwell)
Start Learned tour 5
AUTOPAN
(must be defined with PROGRAM 56
PRESET as below)
Set Home functions
(fixed at 5 minutes)
PROGRAM 54 PRESET
followed by
1 PRESET
= Enable to preset 1
2 PRESET
= Enable to tour 1 (fast)
3 PRESET
= Enable to tour 2 (slow)
4 PRESET
= Enable to learned tour (autopan)
5 PRESET
= Disable home
Reset dome to factory. USE
CAUTION!!
This command will clear all dome
configuration including preset
positions.
PROGRAM 55 PRESET
followed by
PROGRAM 55 PRESET
Define learned tour 5 – START
PROGRAM 56 PRESET
Define learned tour 5 – STOP
PROGRAM 57 PRESET
Enable AUTO180 pan flip
PROGRAM 58 PRESET
SW2
