7
Lighting Instructions
1.
Make sure the regulator is properly secured into the burner end.
2.
Make sure the propane cylinder is tightly threaded into the regulator-hand-tighten only.
3.
Open lid.
4.
Locate lighting access hole on right side of the panel.
5.
Insert match or lighter through access hole next to the burner tube. Keep flame next to burner.
6.
Push gas burner control knob “IN” and turn counter-clockwise to “Lighting Position”
7.
If ignition does not occur in 3-5 seconds, turn burner off. Wait 5 minutes and repeat the lighting
procedure.
Note: lf the burner should go out for any reason, turn control knob to “Off” position. Wait
5
minutes before
attempting to re-light.
If the grill fails to light after the second attempt, check with your local dealer for assistance.
With the burner lit, gently close lid and allow grill to warm up for 20-30 minutes prior to use.
Flames should be blue and stable with no yellow tips, excessive noise or lifting. If any
of these conditions exist, check to see if the air shutter or burner ports are blocked by
dirt, debris, spider webs, etc. If you have any questions regarding flame stability,
please call customer service.
Typical flame pattern and proper
flame height.
TURNING GRILL OFF
I. Open lid.
2. Turn regulator control knob to “OFF”.
3. Caution: Do not attempt to re-light without following all lighting instructions.
4. Allow grill body to cool at least 30 minutes before attempting to move or transport.
To adjust for proper flame, use a
Philips screw driver to loosen
screw. Turn clockwise to close the
air shutter, and counterclockwise to
open. After adjusting, tighten screw
to fix air shutter.
Summary of Contents for 720-0001
Page 10: ...7 ...
