background image

ENGLISH

2

Dear Friend,

Thank you for selecting Bazooka

®

 subwoofer speaker systems for your

stereo system. Today, the Bazooka represents Bazooka Mobile Audio’s

continued commitment to efficiency and design. An innovative

manufacturing process developed by SAS

®

 for the Bazooka provides

consumers with state-of-the-art speaker system design.

At SAS, we take pride in manufacturing the most revolutionary bass speaker

systems ever created, featuring our patented Bass Tubes

®

 enclosure design,

and we hope you will take pride in owning them.

Several years ago, we realized that efficiency was the wave of the future

in Autosound, so we made a commitment to design, manufacture, and

deliver the most efficient speaker systems possible.

Today we market our patented speaker systems worldwide and the high

quality of the Bazooka brand is well respected by consumers and dealers

of all nationalities.

When properly installed, Bazooka subwoofer speaker systems will give

you years of clean uninterrupted sound reproduction. Therefore, I urge

you to take a few minutes of your time to review this instruction booklet.

It was designed to give you a better understanding of our products and

to explain how to apply them properly.

Thank you again for choosing Bazookas. Our early commitment to quality

has made them the product of choice, and I am sure you will agree that

you have made the right one! Enjoy!

Sincerely,

JON C. JORDAN

President

SAS/BAZOOKA

ENGLISH

HELPFUL HINTS BEFORE YOU BEGIN

PG 3

VEHICLE PLACEMENT RECOMMENDATIONS

PG 4

MOUNTING THE BAZOOKA

PG 5-7

WIRING DIAGRAM

PG 8

SPECIFICATIONS

PG 9

WIRING 

PG 10-12

TROUBLESHOOTING

PG 13-14

WARRANTY

PG 15-16

CONTENTS

1

Summary of Contents for BTA850FH











Reviews: