background image

How to install the FAST-9999 with the FAST-BTAH

Disconnect negative battery clamp from battery. 
For easiest installation remove the radio and disconnect
the harness from the back of the radio. 

(+) 12V Power. Turns on when ignition/accessory is on. 

Blue/White 

Turns on remote accessories (amplifiers, etc.). 

If there is no Remote Amplifier wire, you can often use the
 power antenna wire. 

White

(+) Left Front  Speaker

White/Black

(-) Left Front Speaker

Gray 

(+) Right Front Speaker

Gray/Black

(-) Right Front Speaker 

Remove the top cap. Place the wire 
that is going to be tapped.  In the 
grove of the cap as far down  as it 
will go.

 Make sure not to cross  thread the 

cap when screwing it back in place. 

Make sure the end with the 6  pin Molex connectors is
toward the radio. Run the BTAH harness behind radio, 
dash and along  the edge of the vehicle until you get 
to the place you have decided to mount the tube.

Continue to thread  until the cap
 is tight and the wire is pierced. 

Make sure to attach all 6 of the
FAST-9999 harness wires to 
your OEM harness. 

Plug the FAST-9999 harness into
the FAST-BTAH. Mount grounding
ring and plug the 14 pin connector
into the BASS TUBE.  For more information 
on placement and  mounting, consult
 your amplified tube instruction manual.

FAST-9999

14 pin connector
to the BAZOOKA

Ground to
chassis of
vehicle

FAST-BTAH

Red

Connect the pin tap connectors to the corresponding
wires of your radio harness. Consult your car or radio
manufacturer’s manual to get the correct color codes
for your vehicle.

Rely only on high-grade subwoofers and boxes on our virtual shelves.

Summary of Contents for BTA850FH











Reviews: