5.
Now insert the aluminium rail at its original position.
Take care that the PM5-SA4 plug-
exactly located in the corresponding slot of the
aluminium rail as shown on the second photo below
6.
Remount the lid of the connection terminal box and
close the controller casing.
7.
After completion and verification of the installation
you can reconnect mains power supply to the
PoolManager
®
controller.
6
Technical data
Allowed ohmic resistance
of the connected current input
PM5-SA4 Converter 4-20mA – User Manual
Now insert the aluminium rail at its original position.
-in module is
exactly located in the corresponding slot of the
own on the second photo below.
Remount the lid of the connection terminal box and
After completion and verification of the installation
you can reconnect mains power supply to the
Min.
Max.
0
Ω
400
Ω
7
Menu Configuration
The configuration menu for the
is called up as follows:
Menu Hotkey
Communication & Interfaces
Submenu
Current outputs 4
7.1
Output of measured values
Select the submenu for the current output of the desired
measurement, e.g.
Current output
The following parameters can be set in this menu
Parameter
Possible
settings
Current output
pH / Cl / Br / mV /
O2 / T1
Current output
1.1 / 1.2 / 1.3 /
1.4
(1)
Minimum value
(at 4 mA)
Depends on measurement
Maximum value
(at 20 mA)
Depends on measurement
(1)
Current output x.y means
- x is the No. of the used plug
(usually this is plug-in connector
- y is the No. of the current output
on the PM5-SA4 plug-in module
(2)
The default allocation is as follows
- Current output 1.1: pH
- Current output 1.2: Cl
- Current output 1.3: mV
- Current output 1.4: Temperatur
(3)
These Parameters can be used to adjust the desired
measuring range which is output on the 4
current output. The minimum
corresponds with the minimum
the maximum value corresponds with
current signal of 20mA.
The default settings are as follows:
Minimum. value
(at 4 mA)
pH
0,00 pH
Cl or Br
0,00 mg/l
mV
0 mV
O2
0 l
T1
0°C
4
guration
The configuration menu for the PM5-SA4 plug-in module
Interfaces
4-20mA
:
Output of measured values
Select the submenu for the current output of the desired
Current output pH
.
The following parameters can be set in this menu:
Possible
settings
Default setting
(default-set
Europe)
Current output
1.1 / 1.2 / 1.3 /
Depends on
measurement
(2)
Depends on measurement
(3)
Depends on measurement
(3)
means:
of the used plug-in connector
in connector 1)
the No. of the current output
in module
The default allocation is as follows:
pH
Cl or Br
mV or O2
Temperature T1
can be used to adjust the desired
measuring range which is output on the 4-20 mA
The minimum value always
corresponds with the minimum current signal of 4 mA;
e corresponds with the maximum
The default settings are as follows:
. value
mA)
Maximum value
(at 20 mA)
0,00 pH
10,00 pH
0,00 mg/l
10,00 mg/l
0 mV
1000 mV
10 l
50 °C