Bayliner 2452 Classic Cruiser, Owner'S Manual

Page: 32 / 64

Chapter 6: Plumbing 2452 Classic Cruiser • Owner’s Manual Supplement
26
Water Heater
•
The water heater is connected to the AC power system, therefore, you must make sure that the water heater
breaker on the AC panel is turned On before water will be heated.
•
Read the manufacturer’s instruction manual supplied in your boat’s owner’s packet and observe the
warnings above.
Winterizing the Water Heater
1. Turn Off the water heater breaker.
2. Disconnect the hose (A) attached to the pres-
sure relief valve (B).
3. If there is any water in this hose, drain it into
the bilge or into a bucket.
4. Open the pressure relief valve (B).
5. Open the drain valve (C).
•
Leave the pressure relief and drain valves
Open until you fit out the boat after storage.
HOT HAZARD!
Water heated by the water heater can reach temperatures hot enough to scald the skin.
WARN I NG!
!
WATER HEATER DAMAGE HAZARD!
•
DO NOT turn on the water heater electrical circuit on the AC panel until the water heater
tank is COMPLETELY filled with water.
•
Even momentary operation in a dry tank will damage the heating elements.
•
Warranty replacements WILL NOT be made on elements damaged in this manner.
•
The tank is full if water flows from the tap when the hot water is turned On in the galley.
•
The water heater should be drained and the power turned OFF when the possibility of
freezing exists.
CAUTI O N!
!
NOTI C E
If your boat is connected to shore power but the water heater is not working:
•
Make sure the water heater circuit breaker on the AC panel is switched On.
If the circuit breaker on the AC panel is On, but the water heater is still not working:
•
Consult with your dealer about checking the "push to reset" circuit breaker located on the
water heater.
A
B
C