Bayliner 2452 Classic Cruiser, Owner'S Manual

Page: 34 / 64

Chapter 6: Plumbing 2452 Classic Cruiser • Owner’s Manual Supplement
28
Portable Toilet (If Equipped)
Read the manufacturer’s operating instructions supplied in your owner’s packet before using the portable toilet.
Marine Head with Holding Tank (If Equipped)
•
Read the marine head opera-
tion and maintenance man-
ual (included in your boat’s
owner’s packet).
•
The holding tank is plumbed
to a waste fitting on the deck
for dockside pump-out.
•
Check the content level of
the holding tank by looking
at the side of the tank.
•
Empty the holding
tank often.
Using the marine head:
1. Open the head’s seawater intake valve (seacock).
2. Before using the head, pump enough water into the bowl to wet the sides.
3. After use, pump until the bowl is thoroughly cleaned. Continue pumping a few more times to clean the lines.
4. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
Winterizing The Marine Head
1. Shut Off the intake seacock, and pump the head until the bowl is dry.
2. Remove the drain plug in the base and pump again to remove all of the water.
•
Do not fill the bowl with anti-freeze.
•
Close the intake seacock while the boat is underway or whenever the boat is left moored in the water.
NOTI CE
Check with local authorities for regulations regarding the legal use of marine head systems.
WATER TANK
HOLDING
TANK VENT
HOLDING TANK
VENT HOSE
WASTE PUMP-
OUT HOSE
MARINE
HEAD TO
HOLDING TANK
HOLDING
TANK
WASTE PUMP-OUT
DECK FITTING