8
4.2.2. Entering Setup & Calibration
Press
and
keys simultaneously to enter the “Setup and Calibration” menu.
The transmitter indicates the started setup mode by flashing the two LEDs on the front
panel three times sequentially. Then Green LED flashes.
4.2.3. Setup & Calibration
The status of the LEDs on the front panel indicates the setup step as seen below. You can
go to the next step by pressing the
key. Calibrate the scale and adjust other
parameters as indicated below:
STEPS LED’s POSITION DESCRIPTION
GREEN RED
SPAN ADJUST
KAZANÇ AYARI
Flash Flash
Load the scale. The load value must be between 10% to 100% of
your maximum and check analog output value :
:
Analog output value is set as automatically to 10 VDC or
20 mA when pressed this key.
ZERO ADJUST
: Analog output value is set as automatically to 0 VDC or 4
mA when pressed this key.
Unload the scale and check analog output value :
Flash Flash
Flash Flash
:
Return to the operation mode.
Summary of Contents for TX 1
Page 1: ...TX 1 WEIGHT TRANSMITTER OPERATIONAL MANUAL 08 2012...
Page 13: ...12 Notes...
