Starting the ARN
114200 Rev. A
2-9
To use the netboot option:
1.
Enter the
ifconfig
command (refer to
Table 2-2
) at the command line
prompt and press the Return key.
The following is a sample command:
ifconfig com1 9.0.0.2 255.0.0.0 9.0.0.3
Refer to Appendix A for more information about the
ifconfig
command.
2.
Enter the following command and press the Return key to verify the
configuration you specified in Step 1:
getcfg
The
getcfg
command shows the source -- either local or network -- of the
boot image and the network configuration file. It also shows the interface
configuration that you specified using the
ifconfig
command.
Verify the interface configuration, as shown in
Figure 2-1
.
Figure 2-1.
Verifying the Interface Configuration
ARN0079A
$ getcfg
Boot Options
boot image = local
boot config = network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install