Bay Networks BayStack 350, Using Manual, Page: 100 / 248

Using the BayStack 350 10/100/1000 Series Switch
2-8
304376-B Rev 00
Attaching Devices to the BayStack 350 Switch
This section describes how to attach devices to the BayStack 350 switch ports and
how to connect a console terminal to the switch Console/Comm port. You can use
the console terminal to observe the power on self-test results and setup the switch,
if required, as described later in this chapter.
The BayStack 350 switch has an Uplink/Expansion slot that allows you to attach
optional media dependent adapters (MDAs). The MDAs support a range of media
types (see Appendix B, “Media Dependent Adapters” for more information about
MDA types available from Bay Networks). Refer to the documentation that came
with your specific MDA for information about its cabling and LED indications.
Depending on your network configuration requirements, connect the RJ-45 port
cables, the console port, and any optional MDA port cables. After attaching the
devices to the BayStack 350 switch, proceed to
“Connecting Power ” on page 2-11
to connect the AC power cord and power up the switch.
You can connect the BayStack 350 switch to any equipment that conforms to the
IEEE 802.3 standard, such as the following devices:
• Ethernet networking devices
• Individual workstations or servers
• Other switches, bridges, or hubs
For information about autonegotiation, see “Autosensing and Autonegotiation” on
page 1-13. For troubleshooting possible related problems, see “Autonegotiation
Modes” on page 4-6.
kombk.book Page 8 Thursday, February 18, 1999 10:59 AM