Bay Networks Bay Dial VPN, Configuration And Troubleshooting Manual

Page: 62 / 186

Configuring and Troubleshooting Bay Dial VPN Services
4-4 BayStream Multiservice Software Version 7.2 115623B Rev. 00
##
# include the following command for erpcd-based networks
set port address_origin auth_server
#
set port mode auto_detect
set port type dial_in
##
set port slip_ppp_security y
set port ppp_security_protocol chap
# This could be chap, pap, or pap-chap.
The Remote Annex 4000/5390 contains ports that are used as serial ports or
analog modem ports. In addition to configuring parameters common to all
Annexes, you must also configure port level parameter parameters specific to
analog modems. The value for the type of modem parameter is acquired from
the modems.annex file (default path /usr/spool/erpcd/bfs). You can list the
modems in the modems.annex file using the
modem -l command on the
Annex.
On a Remote Annex 4000/5390, enter the following configuration command
sequence from the
na
or
admin
prompt:
set annex enable_security y
set annex pref_secure1_host <ip address of TMS host - ACP or BSAC>
set annex pref_secure2_host <ip address of secondary security host>
set annex security_broadcast N
set annex auth_protocol <acp or radius>
#
port all
#
set port address_origin acp
set port allow)_compression y
#
set port mode auto_detect
set port type dial_in
set port speed 115200
#
set port type_of_modem <modem type>
set port control_lines both
set port input_flow_control eia
set port output_flow_control eia
#
set port slip_ppp_security y
set port ppp_security_protocol chap
# This could be chap, pap, or pap-chap.