15
6.0
Arranging the Coals – Page 15
6.2 Arranging the Coalbed
NOTE: It is important for the safe operation of the
appliance that the front and rear coal mouldings are
correctly located and in accordance with these
instructions.
1. Carefully position the rear coal moulding into the rear of
the fire. The undercut in the base of the moulding should
rest on the pertruding tabs of the rear coal support. The
back face of the moulding should come to rest on the front
face of the rear coal support and shall be centrally
positioned (Fig. 26). Care should be taken that the rear
coal moulding does not fall forward at this stage.
2. Identify the left and right pieces marked L and R.
Position the side cheeks either side of the rear coal
moulding with the coal shaped moulding towards the front.
The rear face of the cheeks should rest on the rear coal
support with the bottom face resting on the pertruding tabs
of the rear coal support and the fixing brackets used to
hold the burner tray to the sides of the combustion box
(Fig. 27).
3. Carefully position the front coal moulding on the front
part of the burner tray with the front edge of the moulding
behind the lip. The rear edge of the moulding should then
rest on the front of the burner. The front and rear coal
mouldings should be touching each other at both sides of
the firebed (Fig. 28).
Supplied by HeatingSpares247.com
