6
3.0 Operating the Appliance
© Baxi Heating UK Ltd 2009
3.1
Operating Settings
1. Your commissioning engineer should have set up the
operating settings of your Baxi Ambiflo
TM
Heat pump.
2. For the system to operate correctly and efficiently these
settings should not be altered. This section details the user
controls, which your installer should familiarise you with during
commissioning the system. These controls are used to set room
temperatures and operating times.
3. If you are in any doubt please contact your installer or a
qualified heat pump installation engineer. Alteration of some
settings could adversely affect the operation of the Baxi
Ambiflo
TM
system and may also affect the warranty of the unit.
4. As with any heating system there are certain aspects that will
require regular checking and/or maintenance. Any maintenance
or servicing should only be carried out by qualified personnel.
5. If the Ambiflo
TM
has been shut down for a period and turned
off at the isolator, it is important to check the system water
pressure prior to switching the isolator back on. The water
pressure gauge on the right hand side of the unit should show a
minimum of 1bar pressure. If the pressure is below this, top up
the system using the filling point provided. If you are unsure of its
position, or cannot identify it, contact your installer who fitted
the Heat Pump.
3.2
Operating the Time and Temperature Controller
1. The Baxi Ambiflo
TM
Heat Pump has been configured to work
at its optimum efficiency by your commissioning engineer and
the external settings should not be altered.
2. The heating settings are controlled via the Aquaset Controller
which is fitted in your property. Your installer should have shown
you its location and functions.
3. The controller’s icons are shown in Figs 1 and 2 and a
description of the unit’s functions is given below. Fig 1 shows the
display and the user buttons; Fig 2 shows a key of the control
icons and their meaning.
3.3
Time and Date Setting
1. Set the dial to ‘Time and Date’ (Fig. 2 Item 7) to display the
time.
2. Press the ‘+’ button once and the small numbers on the left
hand side of the display will flash. These are the days of the week
shown as 1 to 7. Set the day by using the ‘+’ and ‘-’ buttons then
press ‘OK’.
3. The time will now flash. Set the time using the ‘+’ and ‘-’
buttons then press ‘OK’.
! " ##$%&'(
) $* +
Display
! " ##$%&'(
) $* +
1
3
2
9
8
7
5
4
6
1
Not applicable for U.K.
2
Holiday mode
3
Set back mode
4
Clock
5
Heat mode
6
Off
7
Time and date settings
8
Zone 1 programme
9
Zone 2 programme
K
Ke
eyy tto
o ssyym
mb
bo
ollss
‘+’ button
‘
OK
’
‘-’ button
Fig. 1 Aquaset Controller
Fig. 2
