support (a glove is provided with the coal
pack). It is not necessary to use all the coal or
pebbles supplied.
Fitting the Bolero and Dream fascia.
1.
Fit the fascia to the heater by hooking the
brackets on the rear of the fascia over the
brackets on the heater (See figure 14).
2.
Secure the fascia to the heater with 2 off
screws ‘E’ and 2 off washers ‘F’ through the
holes in the lower side legs of the fascia.
3.
Hook the firefront on to the fascia as in
figure 15.
4.
Position the ash pan cover beneath the
firefront.
5.
Place the loose coals onto the top of the
fuel support (a glove is provided with the
coal pack). It is not necessary to use all the
coal supplied.
Fitting the Carma fascia.
1.
Fit the fascia to the heater by hooking
the brackets on the rear of the fascia over
the brackets on the heater (See figure 14).
2.
Secure the fascia to the heater with 2 off
screws ‘E’ through the holes in the lower
side legs of the fascia.
3.
The rear of the firefront has four screws
that locate into ‘keyhole’ brackets on the heater. Hook
the firefront on to the fascia as in figure 16.
4.
Place the loose coals / pebbles onto the top of the fuel
support (a glove is provided with the coal pack). It is not
necessary to use all the coal / pebbles supplied.
Fitting the Anthem fascia.
1.
Removing the fascia may have moved the magnets
used to fix the fascia to the heater. The magnets should
be located as in figure 17.
2.
Locate the fascia onto the heater. Ensure that the sides
of the fascia sit on the floor / hearth.
3.
Place the firefront in a central position against the
Page 14
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 17. Magnet locations
Figure 16. Carma Firefront location
(Firefront may differ from that shown)
Figure 15. Firefront location
(Firefront may differ from that shown)
