11.3 Assembling the
‘Heritage’ fascia.
(See figure 22).
Step 1.
Lay the fascia face
down on a flat surface.
Step 2.
Unscrew and remove
the lower brackets.
Step 3.
Supplied with the fascia
are two replacement brackets.
Locate the right hand
replacement bracket onto the
fascia and secure with 2 of the
screws previously removed.
Step 4.
Locate the left hand
replacement bracket onto the
fascia and secure through the
lower hole with 1 of the screws
previously removed.
Step 5.
Locate the slider control
and secure through the upper
hole with 1 off countersunk
screw supplied.
Step 6.
Secure the top of the
left hand bracket and bottom of the slider
control using 1 off countersunk screw
supplied.
11.4 Fitting the ‘Luxor’, ‘Opulent’,
‘Heritage’ and ‘Westminster’ fascia.
1.
Fit the fascia to the appliance by locating
the top to the upper hanging brackets (See
figure 23), then attaching it to the body of the
appliance using the two screws supplied (See
figure 24).
2.
Connect the control linkage to the control
pivot plate using the shouldered screw and
using a screwdriver (NOT finger tight only)
(See figure 26).
3.
‘Luxor’ and ‘Opulent’ models only
- Fit the decorative knob to the firefront / ash
pan and place centrally beneath the fascia.
4.
Supplied with the fire is a self adhesive control position label. Peel the backing from
Page 27
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 23. Fitting the fascia (Shown
with Chic fascia)
Figure 22.Heritage fascia.