the label and place as in figure 27.
5.
Locate the lower firefront.
11.5 Fitting the Chic and Envy front fascia.
1.
Remove the packing from the fascia.
2.
The lower fascia section is held in place with magnets.
Hold the sides of the lower fascia and pull gently forward
to remove.
3.
A ‘Hole in the wall’ baffle is supplied with ‘Chic’
models. In elevated installations this baffle will reduce the
visibility of the sealing tape. If required, locate the baffle
as in figure 25.
4.
Fit the fascia to the appliance by locating the
top to the upper hanging brackets (Figure 23),
then attaching it to the body of the appliance
using the two screws supplied. If using the ‘Hole
in the wall’ baffle, place the fascia brackets over
the baffle and secure using the two screws for
securing the fascia.
(See Figure 24).
5.
Connect the control linkage to the control pivot
plate using the shouldered screw previously
removed and using a screwdriver (NOT finger
tight only) (See figure 26).
6.
Chic model only -
Supplied in the fascia pack
are two tubular trim sets. Hang one set at the
top of the fascia and the other at the bottom
(See figure 28).
6.
Envy model only -
Locate the lower
section of the fascia onto the tabs as shown
in figure 29
7.
The lower section of the fascia has two tabs.
Locate these into the slots in the fascia (See
figure 30). It may be necessary to re-position
the magnets that secure the lower section.
Page 28
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 26. Shouldered screw.
Figure 25. Baffle fitting (Shown
without burner for clarity)
Figure 24. Fascia securing
screws (fascia may differ
from that shown).
