11. FITTING THE FASCIA
11.1 Assembling the ‘Luxor’ and ‘Opulent’ fascia.
(See figure 21).
Step 1.
Lay the fascia face
down on a flat surface.
Step 2.
Unscrew and remove
the side infill panel. Discard the
side panel and screws.
Step 3.
Locate the lower right
hand bracket onto the fascia
and secure with 2 off M5 x
8mm screws supplied.
Step 4.
Locate the lower left
hand bracket onto the fascia
and secure through the lower
hole with 1 off M5 x 8mm
screw supplied.
Step 5.
Locate the slider control
and secure through the upper
hole with 1 off M4 x 10mm
countersunk screw supplied.
Step 6.
Secure the top of the
left hand bracket and bottom of
the slider control using 1 off
M4 x 10mm countersunk screw
supplied.
11.2 Assembling the
‘Westminster’ fascia.
(See steps 3-6 in figure 21).
Step 1.
Lay the fascia face down on a flat surface.
Step 2.
Locate the lower right hand bracket onto the fascia and secure with 2 off M5 x
8mm screws supplied.
Step 3.
Locate the lower left hand bracket onto the fascia and secure through the lower
hole with 1 off M5 x 8mm screw supplied.
Step 4.
Locate the slider control and secure through the upper hole with 1 off M4 x
10mm countersunk screw supplied.
Step 5.
Secure the top of the left hand bracket and bottom of the slider control using 1
off M4 x 10mm countersunk screw supplied.
Page 26
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 21. Luxor and Opulent fascia. (Fascia and
bracket design may differ from those shown)
