Important electrical safety.
The heater must
not
be located in front of or under an electrical socket, the socket must
always be accessible in order to disconnect the heater from the electrical supply for
maintenance and cleaning.
Important! This heater must be earthed.
!
The heater is supplied with a 3 pin 13 Amp fused
re-wireable plug with 1mm² 3 core cable.
!
The wires in the cable are coloured in
accordance with the following code: -
Live = Brown
Neutral = Blue
Earth = Green / Yellow
!
The electric cable must be safely routed from the
heater to an electrical socket.
Moving the cable guide.
At the base of the heater you will find an electric
cable which runs through a rectangular plastic cable
guide. As supplied the cable guide is fitted into the
rectangular cut-out on the right side of the heater. If
required, the cable guide can be removed and put in
the rectangular slot in the centre or left hand side of
the heater. For removal and fitting please see the
following sections.
Removing the cable guide
1.
Before removing the cable guide please note that
the wider part of the cable guide is on the outer edge
of the base (See figure 1- Item 1).
2.
To remove the cable guide push and lift the tab on
the bottom. The bottom of the cable guide will open
(See figure 1- Item 2).
3.
Lift the electric cable clear of the cable guide.
4.
Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1- Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the wider part of the cable guide has to be fitted
Pa ge 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 1. Removing and
positioning the cable guide.
Item 1
Item 2
Item 3
Item 4
