9. HOTBOX INSTALLATION
9.1 Method 1 - Front fixing to fireplace surround.
1.
Make sure that the fireplace front surround
area is sound enough to take the fibre plugs
and wood screws. If necessary, make sound
with a suitable cement.
2.
Place the hotbox centrally in the fireplace
in the position in which it is to be
permanently installed. If a concealed
connection is being used, insert the hotbox
into the fireplace feeding the supply pipe
through the pierced hole in the rear grommet.
3.
Mark the fireplace front surround through
the four fixing holes in the side flanges of the
hotbox (See figure 15).
4.
Remove the hotbox. Drill
four holes in the fireplace front
surround at the marked
positions using a no.12 masonry
drill.
5.
Insert a fibre plug into each
hole.
6.
Place the hotbox back in
position in the fireplace.
7.
Fit a wood screw through
each hole in the hotbox flanges
and tighten to seal the box to
the fireplace surround.
9.2 Method 2 - Cable
retention and floor fixing.
1.
Make sure that the relevant
areas at the fireplace back or
floor are sound enough to take
the eyebolts and screws. If these
areas have deteriorated due to
prolonged use they should be
made sound with a suitable
cement.
Page 22
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 16. Eyebolt positions
Figure 15. Front fixing
