7.
There is a length of self adhesive foam
seal supplied with the fire. This will need to
be fitted to the outer rear edges of the side
and top flanges of the hotbox. Cut a 485mm
length of foam seal. Be careful not to
stretch the seal when measuring. Remove
the protective backing from the foam seal
and fit this to the rear of the top flange (See
figure 13). Cut two 580mm lengths. Fit
these to the rear outer edges of the side
flanges. Ensure that there is no gap between
the foam seals where they meet at the top
flange (See figure 13)
8.
This appliance is supplied with a rear
ceramic support bracket. Fit this using two
screws supplied (See figure 14).
Page 21
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 14. Fitting the rear ceramic
support.
Figure 13. Fitting the foam seal
