Fit the burner baffle to the front flanges of
the burner. To do this, place the baffle
against the front flanges of the burner and
lower into position. The return edges on the
rear of the baffle should slot over the front
flanges of the burner (See figure 36).
12.2.4
“Icon “ fascia
Place the fascia against the fireplace front
surface so that the two retaining plates at the
back of the fascia are directly above the two
upper retaining brackets at the top of the
convection box. Lower the fascia unit
making sure that the ears on the fascia retaining
plates locate fully over the sides of the convection
box brackets (See figure 37).
Swing the bottom control linking bar towards the
centre of the fire to clear the right side of the
fascia. Fix the bottom of the fascia unit to the
convection box with two screws (See figure 38).
12.3
All fascia
Align the hole near the bottom of the control
linking bar with that in the control pivot
bracket. Join them with the knurled
shouldered screw (See figure 39). Make sure
that the isolating valve is closed. Slide the
control button fully from top to bottom and
back to make sure that the slide and pivot
mechanisms move smoothly. Note that some
resistance should be felt when the slide
button reaches the “burner fully on” position
Page 33
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 38. “Icon”fascia bottom location
Figure 37. “Icon” fascia
top location
Figure 36. Fitting the burner baffle
(Dream model only)
