IMPORTANT:
Before you make any connections, disconnect the negative battery terminal from the
battery. This will reduce the chance of electrical damage to the vehicle.
Power Wire (Large Gauge Red Wire)
:
Route the large red wire to the positive terminal of the
battery. Loosen and remove the 10mm nut on top of the terminal that secures the actual terminal to the
battery. Put the amplifier power wire ring over the bolt, and tighten the nut back down with the terminal on
the battery. This is the primary power supply for your new amplifier. Connect the other side of the power wire
to the
+12V
terminal on the amplifier.
ONLY
when both sides of the wire are connected should you install the
included fuse into the in-line.
Ground Wire (Large Gauge Black Wire)
:
We recommend using the factory grounding point shown above right, on the outer wall on the driver’s side of
the vehicle.
Remote Turn-On Connection (Small gauge Blue Wire)
Let’s first disconnect the harness from the amplifier as shown below:
With the harness removed, take a close look and note that there are two plugs inside of the main
housing:
4 of 13
Any reproduction, distribution, modification, or dissemination of these instructions without written permission from Bavarian Soundwerks is
expressly forbidden and a violation of international copyright law. Any violation will result in prosecution to the full extent available under the
law!
© Bavarian Soundwerks, LLC.
2195 Defoor Hills Rd., Suite D, Atlanta, GA 30318
P: 404.963.8857 |
www.bavsound.com