Baumuller b maXX BM4-O-CAN-03, Instruction Handbook Manual

Page: 36 / 70

Procedure of commissioning
Instruction handbook CANopen slave BM4-O-CAN-03
Document no. 5.02014.06 Baumüller Nürnberg GmbH
36
of 68
6.6
Recognizing the
CANopen slave m Read and observe the Z General safety instructions – on page 25.
m The chapter „Mounting and Installation“ must be observed.
m Switch on the b maXX 4000.
NOTE
The option module CANopen slave must not be plugged or unplugged if the b maXX device
is switched on. Switch off the device before plugging or unplugging.
Function test After switching on the LEDs light up sequentially (described in Z LEDs CANopen slave for
b maXX PLC – on page 34).
The option module CANopen slave displays then with H1 to H4 off that the module is
waiting for configuration via b maXX PLC. The function test is finished.
If the option module is configured, the LED H1 shows the internal state of the CANopen
slave according DR303-3. See b maXX PLC Z Commissioning – on page 34.
6.6.2 Commissioning CANopen slave for b maXX controller
The commissioning of the option module CANopen slave is divided into the following
sections:
1 Recognizing the option module CANopen slave
2 Testing of the CANopen-Slave-module
Recognizing the
CANopen slave m Read and observe the Z General safety instructions – on page 25.
m The chapter „Mounting and Installation“ must be observed.
m Switch on the b maXX 4000.
NOTE
The option module CANopen slave must not be plugged or unplugged if the b maXX device
is switched on. Switch off the device before plugging or unplugging.
Function test After switching on the LEDs light up sequentially (described in Z LEDs CANopen slave for
b maXX controller – on page 35).
If the option module is configured, the LED H1 shows the internal state of the CANopen
slave according DR303-3. See b maXX controller Z Commissioning – on page 35. The
function test is finished.