16
o
Do not leave a gap in the sealing agent or overlap the thickness.
o
IMPORTANT:
Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future if it needs to be serviced.
(A)
Sealing strip
(B)
Clamp
(C)
Screw
Place the clamp
(B)
over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw
(C)
through the clamp
(B)
so that
the clamp is attached to the hob, but so that you can still adjust
the position of it.
o
Carefully turn the hob back over and then gently lower it into the
o
On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. Then fully tighten the screws
(C)
to secure the hob into position.
Gas connection
This appliance must be installed by a competent
person in accordance with the current versions of
the following UK (United Kingdom) or ROI (Republic
of Ireland) Regulations and Safety Standards or
Important information
supplied to run on
natural gas only
and cannot be
used on any other type of gas without modification.
o
aperture hole that you have cut out.
their European Norm Replacements.
o
This hob is
Summary of Contents for BHG642R
