Baumatic BHG642R, Instruction Manual, Page: 21 / 28

21
Gas tap maintenance
These maintenance operations MUST ONLY be carried
out by a GASSAFE registered engineer.
a gas tap becomes stiff to operate, then you should proceed as
follows:
o
Remove the control knobs, pan
screws and clamps.
o
Remove the hob from the workt
protective covers.
o
Disconnect the fixings holding th and
separate the assembly. Then clea
a cloth dampened with solvent.
o
Lightly smear the cone with high temperature grease,
reassemble into position and rotate a few times.
structed with
grease.
components and perform a gas
soundness test.
o replace a gas tap, then you should proceed
s follows:
o
Remove the control knobs, pan supports, burners, hob fixing
ia panel and
separate the assembly.
Disconnect the gas pipe from the gas tap, and then
d
s
IMPORTANT: Before carrying out any maintenance operations,
disconnect the appliance from the gas and electricity supplies.
If
supports, burners, hob fixing
op and remove any underside
e tap to the fascia panel
n the cone and seating, with
o
Remove the cone again and remove any excess grease,
making sure that the gas ducts are not ob
o
Carefully reassemble the
If it becomes necessary t
a
screws and clamps.
o
Remove the hob from the worktop and remove any underside
protective covers.
o
Disconnect the fixings holding the tap to the fasc
o
isassemble them from the gas rail by removing the fixing
crews.
o
When fitting a new tap, ensure that a new gasket is used.