40
m.
as, the adjusting screw must be tightly
screwed in.
out by quickly turning from
maximum flow to minimum flow. If it does then remove the control
in
once the adjustment has been made.
pletion carry out a gas tightness test.
Gas tap replacement
m the electricity
p ly before changing the gas taps.
s.
o
Unscrew the six fixing screws (B) which lock the side profiles
and remove it.
o
The correct adjustment is obtained when the flame has a length of
about 3 – 4 m
o
For butane/propane g
o
Refit the control knob.
o
Make sure that the flame does not go
knob and make further adjustments to the gas flow, testing it aga
o
IMPORTANT: On com
All work must be carried out by a GASSAFE registered
engineer.
IMPORTANT: Always isolate the cooker fro
u p
s
o
Remove all pan supports and burner heads.
o
Unscrew the burner fixing screws (A) (four for the triple crown
burner and two for all others) as shown in the diagram below:
o
Pull out the knob
Summary of Contents for BCD1205SS 120cm
Page 1: ...y 1 BCD1205SS 120 cm Twin cavity Dual fuel range cooker...
Page 45: ...45...
Page 46: ...46...
Page 48: ...48...
