1. Lower mulcher to ground.
2. Set parking brake, stop engine and remove
key.
^
WARNING
Moving parts can crush and cut�
Keep clear of moving components�
Follow lockout procedure before
servicing�
3. Open inspection cover (A).
4. Loosen hydraulic motor mounting bracket.
5. Remove shaft pulley bolt (B) and washer (C).
6. Remove three hub bolts (D). Place hub bolts
into threaded holes (E) in hub (F).
7. Evenly tighten bolts to push pulley (G) off of
hub (F).
8. Remove hub (F), pulley (G) and belt (H). It may
be necessary to lightly tap hub if hub stuck to
shaft.
9. Install belt, pulley and hub onto shaft.
10. Install washer (C) and shaft bolt (B). Tighten
bolt.
5.4 Replace Belt
11. Align pulley holes with non threaded holes in
hub (F) and install bolts (D).
12. Place a straight edge (I) on drive pulley and
rotor pulley. Pulleys must be aligned or belt
will wear quickly. Adjust pulley alignment as
necessary and tighten bolts (D).
13. Belt deflection (J) should be 0.5 in. (13 mm) at
4.25 lbs of force.
14. Adjust tension and tighten motor mounting
bracket.
15. Close inspection cover (A). Do not operate
mulcher with cover (A) open or removed.
H
G
F
C
B
D
E
J
H
I
19