^
WARNING
Drilling, sawing, sanding or machining
wood products can expose you to wood
dust, a substance known to the State of
California to cause cancer�
Avoid inhaling wood dust or use a dust
mask or other safeguards for personal
protection� For more information go to
www�P65Warnings�ca�gov/wood�
^
WARNING
Wear an approved dust mask or
respirator�
Follow local, state and federal
regulations�
Although the cutter has been carefully inspected
and checked prior to shipment from manufacturer,
it is recommended that the unit be thoroughly
inspected.
Check all bolts for tightness and remove all
shipping tags, bags, skids, and blocking.
Remove any masking materials affixed during
painting. Inspect the skid-steer and any accessory
equipment to Verify that nameplates and all safety
warning, caution signs and decals provided with
the equipment are in place and clearly visible.
Visually inspect the unit before each start up.
Check for loose or missing parts and any damage
that may have occurred during moving or shipping.
Review all skid steer pre-start instructions, and
ensure that all recommended steps and procedures
have been followed.
4 OPERATION
4�1 Preparation For Use
4�2 Removing Skids Or Blocks
If the cutter is shipped on a skid it will be in a vertical
position and must be lowered to horizontal position
before use. Due to the weight of the machine,
CAUTION must be taken when doing this. Use
an appropriate lifting device to lower machine into
operating position, failure to do so could result in
serious injury or death.
Always keep the weight of the machine in mind.
Never position body in line of impact or in anyway
underneath the machine.
8
