5 SERVICE AND MAINTENANCE
^
WARNING
Moving parts can crush and cut�
Keep clear of moving components�
Follow lockout procedure before
servicing�
1.
Park cutter on a level surface.
2.
Lower cutter to the ground.
3.
Shut off skid steer engine, remove key and
lockout control panel.
4.
Inspect blades (A) and blade carrier (B) for
wear and damage. Do not replace just one
blade. Replacing only blade can cause cutter
to be out of balance. Replace blades in pairs.
A
B
5�1 Replace Blades
5.
Remove access cover (C).
C
6.
Rotate blade carrier by hand so blade nut (D)
is under access hole.
7.
Remove nut (D), bolt (E) and blade (A).
D
F
E
8.
Install new blade in reverse order of removal.
Tighten nut to 795 lb-ft (1078 Nm) of torque.
9.
Repeat steps 6-8 for other blades.
Note:
Parts breakdown can be found on
Baumalight’s website
. www.baumalight.com
12
