Baum BAUMCUT 31.5, Operating Instructions Manual, Page: 90 / 104

K6 - 2
1 2 3
4 5 6
7 8 9
C 0
x
D
i
PROGRAMMABLE
The knife change should only be carried out by specially trained
personnel
Tools required: 1 Knife wrench
1 Knife guard
2 Knife holders
Removing the knife
1. Select display "Main menu" (Function survey) with key .
Make selection "3 Knife".
Select "2 Knife change"
2. Bring turning knob (i), located beneath the front table, to position "Knife
change"
3. Press both cut buttons and keep them pressed until knife bar stops
automatically at the lower position
4. Remove knife screw at the very left-hand side; turn knob (i) to "0 -
position" < knife bar moves upward >
5. Loosen both knife screws (a) at the two knife bar slots (b).
Screw both handles of the knife guard (c) into the now accessible bolt
holes
6. Remove the remaining knife screws (knife is fixed to the knife bar by the
two handles)
7. Pull knife guard forward by means of the two handles (de-activate
clamping) and pull the knife downward, out of the knife bar.
8. Deposit knife in knife box!!
Remove knife guard*
* HANDLE THE KNIFE WITH UTMOST CARE!
WHEN TRANSPORTING THE KNIFE WITHOUT
KNIFE BOX, USE ALWAYS THE KNIFE GUARD.
Knife change
6.0 Knife Change
"0-position"
position
"knife change"
i
a
b