How to install a perforator on a 714XLT
(Continued from previous page)
10. Slide the
female perforator collar
until the wide groove of the female collar is under the
perforator blade. Leave it loose for now. The
perforator stripper
should be between the
perforator blade assembly and the female perforator collar.
11. Slide the
left pullout tire
you just removed back on the bottom slitter shaft until it is directly under
the left pullout tire on the top slitter shaft and tighten the brass point set screw to secure the
pullout tire assembly to the shaft.
12. Replace the
left slitter shaft boxing
on the slitter shaft in reverse order as you removed them.
Install the
socket head bolt
that fastens the left slitter shaft boxing to the slitter shaft assembly
and tighten it.
13. Move the
female perforator collar
until the sharp edge of the blade is against the edge of the
wide groove in the female perforator collar and tighten the brass point set screw in the collar to
secure it in place. The blade against the edge of the groove creates a scissors action as the shafts
turn.
THE PERFORATOR BLADE IS SHARP. CAUTION SHOULD BE EXERCISED WHEN
WORKING AROUND THE PERFORATOR BLADE
.
14. Replace the slitter shaft assembly in reverse order as it was removed. Extra care should be made
to insure the slitter shaft boxings are secure on all four pins in the frame and the gears all mash
properly. Turn the hand wheel a couple times to insure the slitter shaft assembly is in proper
position.
15. Raise the
perforator stripper
until it is not rubbing the
blade holder
and along the side of the
perforator blade
and it will allow a sheet of paper to go under the stripper and above the female
perforator collar without jamming them lock it in place. The purpose of the stripper is to strip the
sheet off of the perforator blade otherwise the sheet would wrap around the top slitter shaft.
16. Replace the feed table in reverse order it was removed. Again turn the hand wheel to be sure
every thing is in the proper place and nothing is rubbing, run a sheet through to see if the
perforator is in the proper location. If not loosen the setscrews and move the assemblies where
you want them on the shafts and lock with the brass point setscrews. Turn the hand wheel to
insure nothing is rubbing and check it again.
Continued on next page…
Baumfolder Corporation P.O. Box 728 1660 Campbell Rd, Sidney, Ohio USA 45365 Copyright © 2002
Phone 1-800-543-6107 or 1-937-492-1281 Fax 1-937-492-7280 email: [email protected]
